Olicom Ethernet MCA 10/100 Adapter, Manual To Operations

Page: 50 / 88

43
Ethernet MCA 10/100 Adapter v. 1.0, P/N: 710001414 Software Installation
IBM OS/2 Environment
IBM Extended Services 1.0 and IBM LAN Server products use the NDIS
interface. The NDIS 2.0 drivers for DOS and OS/2 are also referred to as MAC
drivers.
IBM NTS/2 and IBM Extended Services
This section describes how to install the MAC driver for the adapter with IBM
NTS/2 and IBM Extended Services.
1. Start the Communication Manager and select “Advanced”, “Configuration”,
“LAN Adapter and Protocol Support” and “Copy additional network adapter
drivers”.
2. When requested to do so, insert the Olicom Driver Disk and enter the path to
the driver:
A:\IBM\NDIS.OS2
3. When the network driver has been copied, select “Configure workstation” and
configure the workstation (refer the IBM documentation).
See also “Configuring the NDIS 2.0 MAC Driver” in the Olicom online
documentation.
IBM LAPS - LAN Server 3.0
This section describes how to install the MAC driver for the Ethernet MCA 10/100
Adapters with LAN Server 3.0:
–
during installation of LAN Adapter and Protocol Support (LAPS)
–
after installation of LAN Adapter and Protocol Support (LAPS)
Install the MAC Driver during Installation of LAPS
1. Insert the “IBM Network Transport Services/2, LAN Adapter and Protocol
Support” diskette and run the LAPS program (that is A:\LAPS).
2. Select “Install” in the LAN Adapter and Protocol Support program’s main
menu. The program installs LAPS on the hard disk.
3. At a certain stage during installation the “Protocol Support programs main
menu” reappears, but this time with the “Install”, “Configure”, “Remove”,
“Exit” and “Help” options selectable.
Proceed with the installation as described in “Install the MAC Driver after
Installation of LAPS”, step 2.