2
USE AND MAINTENANCE
02_OED_OLI_00_EN
12
OLI EASY DISPLAY
2.10.
ERROR CODES
ATTENTION:
Depending on the type of fault, the system could prevent the motor from
starting or run at reduced power.
The following table lists the possible faults and the 4-character codes displayed in the
error messages.
Fault code
Description
0001
Communication problem with the battery. The battery
status data could be displayed incorrectly.
Check that the battery wiring and contacts are intact
and properly connected.
0101
Communication problem between drive unit and HMI.
Check that the wiring is intact and properly connected.
0104
Speed sensor not detected.
Check that the alignment between the magnet and the
speed sensor is correct.
Check that the speed sensor is properly installed and
connected.
0105
Non-compliant torque meter signal.
The torque transducer signal has a fault. Operation at
reduced power.
0106
Non-compliant torque meter offset.
The torque transducer signal has a fault.
0801
Motor rotation sensors faulty.
0802
Pedal rotation sensors faulty.
0804
Excessive controller temperature.
The temperature sensor inside the controller has
detected a temperature higher than the danger
threshold.
In the event of a malfunction, the display automatically
shows a 4-character
K
code relating to the error
corresponding to the fault found.
Error codes are shown on the right of the display and
highlighted by an exclamation point.
To clear the error codes turn the unit off and on again.
K
