10
OLCT10N
Manual
Before connecting the detector to the control unit, please inhibit any installation
alarms to avoid unexpected triggering during operation.
*
Connecting is made according to the following schematic:
Figure 3 : principle of connecting modules on a MX43 line.
Configuration of communication
Detector address
All the digital modules on a line must be
identified by a unique address.
Switches 1 to 5 of the configuration block of
each module make it possible to establish
an address number (1 to 32) in binary
mode.
In the illustration to the right, the address 9
(10010) has been defined.
The
Addressing Table
below lists the
possible combinations.
004
Figure 4
: Switches of
address configuration.
The connection of the cable between the detector and central unit should be
made with the power off. The site should be at equal potential
MX43 line terminal
Ground
Terminal
Detector terminal
