24 | dac8 Stereo O
wner’s
Manual
| okto research
Mains voltage selection
Because the analog circuits of the unit are powered by a linear power supply, the mains
voltage selection requires selection of different transformer primary windings.
Each dac8 Stereo leaves our factory with the input voltage set according to the mains
voltage of the country from which the order was placed, unless specified otherwise. If you
wish to alter this selection at a later time, please adhere to the following steps. For your
reference, this diagram is also imprinted on the power supply module PCB.
1.
Unplug the dac8 Stereo from the mains power source.
2.
Unscrew the 7 screws in the top lid and remove it
3.
Reconfigure wire jumpers on the input terminal block of the power supply module
accordingly:
Troubleshooting
This section is designed to help you identify and resolve potential issues that may arise
during the use of your dac8 Stereo. If you are unable to resolve an issue following these
steps, or if the problem is not listed here, please contact us for further assistance.
Issue 1: USB input not recognized
Recommended action: Perform a power cycle on the unit by unplugging it from mains and
then plugging it back in after a 5-second pause.