O
KLAHOMA
S
OUND
C
ORPORATION
4
INSTALLATION OF HARDWARE
1) Lay out the wood panels as shown in diagram “A” (make sure the factory drilled
holes are facing upwards). You can determine the top of the front panel by identi-
fying the edge cut on an angle.
2) Identify the holes numbered "1" in Diagram A. Screw the bolts into the inserts with a
#2 Phillips-head screwdriver. Be sure to tighten the screws all the way. Note: Be
careful not to over-tighten the bolts as this will strip the wood!!
3) Insert the cams in the larger holes as shown on diagram. MAKE SURE THE ARROW ON
THE CAM IS POINTING TO CLOSEST EDGE & ALIGNED WITH THE HOLE ON THE EDGE.
5) On the BOTTOM panel, screw in the four casters. The locking casters should
screwed into the bottom closest to the T-Molded contoured edge. The second pair
of non-locking casters should be screwed in closest to the unfinished edge.
6) The 4 corner braces should be screwed into the bottom panel. There are pre-drilled
holes to guide you for proper placement. (Diagram A)
Diagram A
1
1
1
1
1
1
1
1 1
1
1
1
1
1
