oklahoma joes 20209106, Assembly Manual

Page: 30 / 40

OKLAHOMAJOES.COM
30
CLEARING AN AUGER JAM
Auger jams can occur from time to time with normal use of the grill.
Jams can be caused by a number of factors such as using damp/
crumbling pellets, leaving pellets in the system for extended peri -
ods of time or not properly running the shutdown process. In some
cases, a jam may be accompanied by an ER5 message on the Pit
Control screen but ultimately, an auger jam will prevent the auger
from feeding pellets into the firepot, thus causing a flameout.
Visit our FAQ on Oklahoma Joe’s.com for step by step video instruc
-
tions and demonstration of this process.
First, you’ll need to assess the auger:
1. Drain pellets from QuickDraw Hopper so you can see the
auger at the bottom
2. Turn the grill on and set to “HIGH” and watch for auger
rotation.
Note – the auger should begin turning immediately for a few
seconds, then it will pause for 90 seconds, then continue
normally.
3. If you do not see auger movement after several minutes, the
auger may be jammed, preventing it from feeding pellets
into the firepot.
Addressing a minor auger jam (“Shake” method):
1. Unplug the grill
2. Remove the guard in the hopper by unscrewing the 4 screws
holding it in place
3. Using your screwdriver, slide the auger back and forth,
in-line with the auger tube, attempting to break the jam
loose.
4. With tools and hands clear of the auger, turn the grill on
and set to “ HIGH ” and watch for auger rotation in the hop -
per
Note – the auger should begin turning immediately for a few
seconds, then it will pause for 90 seconds, then continue
normally.
If you still do not see movement, try the next method.
Addressing a minor auger jam (“Snake” method):
1. Unplug the grill
2. Remove warming racks, grates and baffles and shift heat
baffle to SEAR MODE
3. Using a heavy gauge wire, carefully try to break up the jam
by sliding the wire into the firepot side opening of the au -
ger tube
4. With the wire fully removed, turn the grill on and set to
“ HIGH ” and watch for auger rotation in the hopper
Note – the auger should begin turning immediately for a few sec -
onds, then it will pause for 90 seconds, then continue normally.
If these methods do not clear up your issue, it’s likely you’ll have to
remove the auger to clear the jam. Please visit our FAQ on Oklaho -
ma Joe’s.com for step by step video instructions and demonstration
of this process or call Oklahoma Joe’s Customer Service at :
AUSTRALIA – Sitro Group Australia Pty. Ltd., 1-300-174-876 Ext. 1,
Email: service.group@sitro.com.au
NEW ZEALAND – Aber Holdings,
0800 161 161,
Email: service@aber.co.nz
COMMON TROUBLESHOOTING