Okina USA SS10W-C100H, User Manual

Page: 16 / 19

16
TROUBLE SHOOTING & MAINTENANCE
Failure Possible Cause Solutions
Electricity without action,
no images, light does not
shine Connect the wrong power
cord Corrections
Power supply is damaged Replace
Bade fuse Replace
Power cord connection is
bad Exclusion
Power are self-test, there
are images, not control IR uniform dome camera
address codes, the baud
rate setting does not To reset the high speed
dome address code and
baud rate
Wrong protocol Corrections
RS485 line reversed or
open Check wiring RS485
control line
Unable to complete
self-test, there are
images associated with
motor tweet sound Mechanical failure Maintenance
Camera tilt Straightenl
Power is not enough Replacement to meet the
requirements of the power
supply. It is best to power
the camera on the
near-infrared uniform
Image instability Video line connection is
bad Exclusion
Power is not enough Replace
Blur Manual focus on the state Operation of any infrared
high speed dome camera
or call a preset point
IR control of a high
speed dome camera
non-stop or delay Power is not enough Replacement to meet the
requirements of the power
supply. It is best to power
on the high speed dome
camera in the vicinity
Check control of the most
distant high speed dome
camera match whether to
join resistance The most far away from
the control of the ball-type
cameras by adding
matching resister
Far from 485 the signal
attenuation Bold line of control
Converter 485 is not
enough driving force Replacement of a source
converter