OKIDATA OF2600, Service Manual

Page: 231 / 410

Page: 139
Service Guide OF2200/2400/2600
Chapter 3 Disassembly & Maintenance
3.2.21 Stacker Cover and LED Head
1. Perform procedures
3.2.03
3.2.05
3.2.19 (except when removing LED Head).
2. Open the copy stacker, by pushing the buttons.
3. Disconnect the flat cable from the PC connector.
4. Remove the LED head while spreading the retainer on the copy stacker.
5. Press inward on the two hooks until the copy stacker is free from the two reset levers.
6. Spread the copy stacker until its free from the lower base, then remove the copy stacker.
NOTES:
Be sure not to touch the lens portion of the LED head.
Under normal circumstances, the PC connector should NOT be removed from the LED head. If it is
removed, use caution NOT to lose the connector pins.
When the LED head is replaced, the LED Head Drive Time may need to be set. Refer to Module 3.3
of this Service Handbook.
When cleaning, refer to Module 3.4 of this Service Handbook.
P/N N/A Cover: Stacker B.2.05
P/N 53069002 Cover: Face Down Stacker (Assembly) RSPL B.2.05
P/N 50104801 Tray: Stacker Cover Extension RSPL B.2.05
P/N 51013801 Guide: Wire RSPL B.2.05
P/N 56111202 LED Head Assembly RSPL B.2.05
Includes the items listed below.
P/N 51014601 Contact: Ground Clip RSPL B.2.05
P/N 56730201 Connector: PC RSPL B.2.05
P/N 56629102 Cable: LED Head RSPL B.2.05