Oki TF-300P, Field Service Manual

Page: 34 / 137

5-7
5.3.10 Document Guide Assembly
(1) Use a straight screwdriver to separate Operational Panel and Doc. Guide Asm.
(2) Setting Spring & Spur Gear
Press downward the Setting Spring and move to longer side. Then Setting Spring and Spur
Gear can be taken out at the same time.
(3) DOC. Guide
¬
Lift slightly and pull the left Document Guide outward to take it out.
-
Lift slightly and pull the right Document Guide outward to take it out.
(4) DOC. Setting Lable
DOC. Setting Lable can be scratched from DOC. Bracket.
5.3.11 Operation Panel Unit
Figure 5-6 Operation Panel Unit
(1) O/P Bracket & Hook Switch Assembly
With a cross screwdriver, loosen 5 pieces of M3X8 tapping screw for fixing O/P Bracket.
Then O/P Bracket can be taken out from O/P Asm. At the same time, pull out Hook Switch
Asm. from O/P Bracket.
¡ °
Note:
Put a softer plate on table to avoid operation panel to be scratched is necessary.
(2) Pull out connectors on the key board and hook switch board . Take out cable from two
mounts.
(3) Buzzer
Loosen two pieces of M2X6 taptite screw for fixing buzzer then buzzer can be taken out.
(4) Key Board, Key Pad, Number Key, Function Key, Facility Key, Stop Key, Start/Copy Key
Use a small cross screwdriver to loosen 10 pieces of M2X6 taptite screw for fixing Key Board
then Key Board, Key Pad, Number Key, Function Key, Facility Key, Stop Key, Start/Copy
Key can be taken out respectively.
(5) Display Panel
Use a straight screwdriver to pick Display Panel from the gap between Display Panle and O/P
on right or left side.
(6) Use a straight screwdriver to peel Quickdial Card Cover from the gap on right side then pick
Quickdial Card.