Using your printer > 33
4.
If the printer is ON line, press
SEL|MENU
(1) to take the printer Offline.
The SEL light goes out.
5.
Press and Hold
SHIFT
, then:
>
Press
LF|Micro Feed Down
(3) to set the TOF higher (the paper moves down).
>
Press
FF/LOAD
|
Micro Feed Up
(4) to set the TOF lower (the paper moves up).
(When you begin pressing the Micro Feed key, the printhead will move to the right).
6.
Press
SEL|MENU
(1) to save the setting and place the printer back on line.
To reset the Top of Form to the factory default, see
“Resetting top of form to the factory
.
T
EMPORARILY
CHANGING
THE
TOP
OF
FORM
To move the Top of Form position lower for one page only
:
1.
Press
SEL
to deselect the printer.
2.
Press
LF
to lower the position of the Top of Form.
R
ESETTING
TOP
OF
FORM
TO
THE
FACTORY
DEFAULT
The factory default setting for the Top of Form (where the printing should begin) is 1" down
from the top of the page.
To reset the Top of Form to the factory default:
1.
Remove paper from the paper path.
2.
Turn the printer off.
3.
Press and hold
PARK
+
QUIET|TOF
while turning on the printer.
4.
Reload paper.
F
ORMS
TEAR
-
OFF
FEATURE
This feature is normally turned off. To use Forms Tear-Off, you must enter the menu and
change the setting to the desired time interval (see
“Changing the forms tear-off setting”
).
The Forms Tear-Off feature allows a printed continuous forms page to be torn off without
wasting paper or adjusting the printer. It can be used for rear feed continuous forms,
bottom feed continuous forms (with the optional push tractor installed), or for top feed roll
paper (with optional roll paper stand installed).
When the printer is turned on, the paper feeds to the tear-off position.
When data is received, the paper automatically moves down to the print position (TOF) and
printing begins.
CAUTION!
If you turn the platen knob when the printer is not at Top of Form,
the TOF will misalign. Always feed the paper to TOF before turning
the platen knob.
NOTE
You can also move the paper down to the print position manually by pressing
TEAR.
Summary of Contents for ML5520
Page 1: ......
Page 69: ...45691602EE Rev1...