Microline 1120 User’s Guide
38
Set Top of Form (TOF)
General Information
The default top of form is set in the printer menu.
The factory default for TOF is 1/4-inch (6.4 mm), equivalent to the distance
down from the top of the sheet to the horizontal midpoint of the first line of
printed characters.
TOF.jpg
You can establish one custom TOF setting for each feed path (Top Cut Sheet
and Rear Continuous Form) and store it in the printer’s memory. This
selection will then automatically appear as the setting for TOF for the
corresponding group in the Menu.
You can also use the control panel switches to set a temporary TOF for one
sheet or one continuous form.
Use the Printer Menu
panel.jpg
Nota
The printer default for TOF is 1/4-inch (6.4 mm).
1.
Turn the printer on while holding down the SEL button.
The printer enters the Menu.
PRINTER CONTROL
prints.
2.
Press SEL repeatedly until the feed path for which you wish to change
the TOF appears:
REAR FEED
or
TOP FEED
.
3.
Press LF/FF repeatedly until
CONTINUOUS PAPER TOP OF FORM
or
CUT SHEET TOP OF FORM
prints.
4.
Press LOAD/EJECT repeatedly until the setting you wish to engage
prints.
Choices are: 2.12 mm (1/12”), 3.18 mm (1/8”), 6.35 mm (1/4”),
7.62 mm (3/10”), 8.47 mm (1/3”), 10.58 mm (5/12”), 21.59 mm
(0.85"), 23.28 mm (11/12”), 25.4 mm (1”), or 27.52 mm (13/12”).
5.
Press and hold TEAR, then LOAD/EJECT, then LF/FF. This saves your
setting and exits the menu mode.
Summary of Contents for ML1120
Page 1: ...59389401_cvr jpg...
Page 6: ...Microline 1120 User s Guide 6 Back View F1_24_back jpg 1 Tractors 2 Power Cord Connector 1 2...
Page 34: ...Microline 1120 User s Guide 34 1120_bottomfeed_7a jpg 1120_bottomfeed_21 jpg 2 2 1 1...
Page 43: ...Microline 1120 User s Guide 43 Part Numbers Ribbon Black 43571801...