14
13
12
10
5
11
b
8. Raise the
Outside Media Guide
to the closed position and
push the guide inward until it barely contacts the outside
edge of the media.
9.
If your printer does not have an internal
rewinder, then skip to step 14.
10. Remove 24" to 30" of labels from the backing paper
to provide enough backing paper free of labels to
wrap around the
Backing Take-Up Spindle
.
11. Route the label backing down the front of the print
mechanism and around the
Backing Drive Roller
.
12. Wrap the backing under and around the
Backing
Take-Up Spindle
, routing it under the two
Backing
Retainer Prongs
.
13. Manually turn the
Backing Take-Up Spindle
counter-
clockwise to take up all the slack in the backing.
Note: Inspect the media routing and verify
that the path matches that illustrated in the
Media Loading diagram on the inside of the
Top Access Door.
14. Close the
Print Head
and latch it in the down position.
15. Close the
Front Access Door
. After the
Front Access
Door
is closed, the
Top Access Door
may be closed.
These covers have interlock switches and the printer
will not operate if either is open.
15
