6
2
4
3
4
5
1. Open the
Top Access Door
by swinging it up.
1
2. Open the
Front Access Door
by pushing down on
the green
Dispenser Latch
and swinging the door
forward and to the left. This gives access to the print
mechanism on three sides.
Note: The Top Access Door must be open
before the Front Access Door can be opened.
3. Open the
Print Head Assembly
by rotating the green
Head
Latch
counter clockwise. The head is spring loaded and will
automatically raise to the opened position.
4. Pull the
Media Supply Guide
to the outside of the printer to
give the maximum media width.
5. Load the roll onto the
Media Holder
so that the printing
side of the media faces upwards as it unwinds from the
roll. Push the roll all the way to the inside of the printer,
then push the
Media Supply Guide
back in until it fits
snugly against the outside of the media roll.
6. Route the media under the
Media Hold-Down
, through the
Media Sensor Assembly
, under the
Print Head
and out
the front of the print mechanism. Push the media all the
way to the inside of the printer. Clear access is provided
to the label path by pulling the top of the
Outside Media
Guide
down.
Note: Make sure the media is routed through the
Media Sensor Assembly. If it is not, the printer
will react as if there is no media loaded and will
refuse to print.
7. Adjust the media sensor to compensate for irregularities
in the media (i.e.: notch, tag hole, gap, perforation
or markings). The proper position will be media-
dependent. To properly adjust the sensor position,
loosen the green
Sensor Adjust Knob
located on the
bottom side of the
Media Transport Assembly
and move
the sensor in ¼ inch increments (or finer) until the sensor
error is cleared. After the error is cleared, retighten the
green
Sensor Adjust Knob
.
Outside Media Guide
Sensor Adjust Knob
7
8
