Mounting the Desktop (Extension type)
The height of the desktop can be adjusted to 5 levels based on the height of the person using it. Adjust the height of the desktop by
referring to “Height of Desktop” on page 8.
Fig. A
Fig. B
Fig. A
Fig. B
If lighting will be mounted to the desktop, be sure to
mount the lighting mounting clamp to the desktop
unit before assembly. (See page 9.)
CAUTION
Extension
leg
Extension
leg
Shelf holder wire
Extension top panel
Warning label
Screw-type
connector
The extension legs are positioned as shown in .
To change the extension leg position, flip the desk
backward, turn the screw-type connectors
counter-clockwise, remove the extension legs, attach to
the position in , and turn the screw-type
connectors clockwise to tighten in place.
Determine the height of the desktop to
match the child by referring to the figure on
page 8, and set the shelf holder wires so
that they have the same height as the
desktop.
Insert the extension top panel into the shelf
holder wires while sliding from the front.
When sliding, orient so that the warning
label is on the front right side.
*When reassembling from the compact type
desk, the extension top panel is set on the
rear panel back by the shelf holder wires.
Do not mount the bag hook to the hook mounting
position. The length of the bolt is different, and this
could damage the panel.
CAUTION
Desktop
Desktop dowel
*When the optional 3
drawer wagon upper
unit is not attached to
the desk, attach nut
caps to the four
positions specified in
the Fig.
Mount the desktop holder dowels into the dowel holes at
the desktop height determined in step . (2 locations
each on the right and left side panels)
The desktop is placed temporarily on the desktop holder
dowels.
Mount by sliding in the direction of the arrow in the figure.
*Mount all of the desktop holder dowels at the same height.
If any of the dowels are at a different height, the desktop could
become dislodged and is extremely dangerous.
CAUTION
When changing the height of the desktop, first
check that the desktop holder dowels are
mounted, and then remove the connecting bolts.
Securing the desktop and mounting the hooks
Once the desktop is put temporarily in place, insert the rings
into the outer holes of the side panels and rear panel that
match the height, and tighten using connecting bolts.
At this stage, the backpack hook can be mounted to
either the right or left side on the rear of the panel.
When mounting, secure the backpack hook together with
the supplied bolt to the desktop.
Next, if desired, mount the hook on the side of the desktop (1
available location on each side).
Connecting bolt
(40mm)
Ring
Hook
Bag hook
* One
connecting
bolt is left
over when
bag hook
is used.
Connecting bolt
(40mm)
Ring