4
5
×
2
×
1
×
5
×
5
×
2
×
2
×
8
×
12
×
4
×
4
×
4
Desk
Details of Parts
(make sure to check before assembly)
Key
Organizer
tray
Ring
Desktop
receiving
dowel
Cap for insert nut
Swing hook
Level
adjustment
felt
Single-end
connection bolt
(24mm)
Actual size
Connecting bolt
(M6 × 45mm)
Connecting bolt
(M6 × 35mm)
j
k
a
b
g
h
Plug cap
(8mm)
f
c
d
e
i
Side panel
(right and left) ×1
Side panel
Rear panel
(lower)
This face is the under side
Rear panel
(upper) ×1
Rear panel
(lower) ×1
Lower shelf plate ×1
Desktop ×1
Desk
Installation of connecting bolts to side panel and rear panel (lower)
Install five single-end connection bolts of to the right and left side panels, and two locations of
the rear panel (lower).
Turn clockwise to screw in.
Desk
Desk
Desk
Installation of rear panel (lower) and lower shelf plate
Installation of side panel
and rear panel (upper)
Installation of desktop
Install the lower shelf plate to the rear panel (lower) and securely tighten the screw-type connector.
* Assemble the face to which a seal of the lower shelf plate is attached
to the lower side.
Lower shelf plate
* Desktop height is five-stage adjustable.
See page 3 to refer to the height.
Seal of “This face is lower”
Lower side
Securely
tighten
Rear face plate (lower)
Screw-type connector
Install parts of and rear panel (upper) to the right side
panel, and then install the left side panel and securely tighten
the screw-type connector.
When storing the two-stage wagon at desktop heights of
JIS No. 2/3, it is necessary to separate the upper drawer
unit (upper drawer) of the wagon. Please refer to page 11
for installation method.
* When not installing the upper unit of the two-stage
wagon under the desktop, install the caps for nut of at
positions shown in the diagram.
Insert the desktop receiving dowels of (4 locations) into the
desktop receiving dowel holes provided on the side panel, and
temporarily place the desktop.
* Make sure to install all of the desktop receiving dowels at
the same height.
Desktop
Securely
tighten
d
d
d
e
e
e
e
d
Actual size
Use a cross slot screwdriver for assembly.
* An electric screwdriver or electric tool may damage the product,
therefore, use a manual screwdriver.
[About screw-type connector]
Screw-type connector
The screw-type connector is
tightened by turning clockwise.
The screw-type connector is
loosened by turning counterclockwise.
Screw-type
connector
Single-end
connection bolt
(Embedded into the members)
When the arrow is set to the single-
end connection bolt, the connecting
bolt is inserted (removed).
Arrow
Upper side
Assembled
on rear face
Upper side
Assembled
on rear face
[About connection bolt]
Single-end
connection bolt
When screwing the
connection bolts into
the insert nuts, make
sure not to tighten
excessively.
The insert nut may be removed,
or the head of the connection bolt
may be broken.