
10
11
Desktop (install later)
Installation of movable shelf plate
Desk + bookshelf
For installation of the movable shelf plate,
after installing the shelf receiving fitting pin
of , install the movable shelf plate, and
tighten with the connecting bolts of from
the rear of the rear panel.
Installing position of the
shelf plate is two-location
selectable.
h
h
l
l
l
l
Tightening of bolts
Desk + bookshelf
The bolts for the movable shelf plate with drawer and the movable shelf plate can
be tightened from both of above and below, however, tighten
clockwise
from
below
and tighten
counterclockwise
from
above.
When tightening from below
When tightening from above
When tightening
from below
Tighten
* When tightening the bolt
from
below the shelf plate,
turn
clockwise.
Loosen
Tighten
clockwise.
Tighten
counterclockwise.
Tighten
counterclockwise.
When tightening
from above
Tighten
* When tightening the bolt from
above the shelf plate, turn counterclockwise.
Loosen
Installation of movable divider
Desk + bookshelf
The movable divider can be installed to
the desired notch part shown in the
diagram.
Insert the plate from the notch parts on
the right and left sides of the bookshelf
and desk, and slide laterally to install.
Completion
Two-stage wagon drawer unit and lighting
How to store drawer unit
Securely
tighten.
Screw-type connector
Drawer unit
Clamp with
receptacle outlet
Lighting can be installed to the notch parts on the right and left sides of the desk with a clamp.
* Refer to the “Instruction manual” attached to the illumination.
Lighting installing position
When you purchased the dedicated two-stage wagon, it is necessary to separate the drawer
unit (upper drawer) when the desktop height is JIS No. 2 and No.3.
The separated unit can be stored in the fixed lower shelf plate as shown in the diagram.
①
Separate the wagon, and remove the drawer unit and the single-end connection bolts from
the wagon body.
②
Screw the removed connecting bolts into the locations shown in
the diagram.
* The installing location is only the right side toward the main body.
③
Install the drawer unit such that the drawer front panel is directed
upward, and turn the screw-type connectors two positions to the
left in the clockwise direction to tighten.
(So that the front panel is directed upward)