Oilon Lampoassa RE 28-48, Installation And Operation Manual

Page: 35 / 78

1. From the settings menu, select
Special operations
.
2. Select
Reset HP
. 3. Change the setting to
Yes
.
In case of a fault
In the diagnostics menu, select
Reset.
Select
Confirm
.
Through the parameter list
Open the parameter list. Enter the fault menu and select
Reset HP
on line
6711. Switch the line value to Yes .
5.12 Relay test
Use the relay test to test the operation of actuator.
1. Perform the relay test by selecting the desired QX output (and, if required, the UX
signal output) and observing the operation of the actuator.
2. Finish the test by changing the relay test function setting (line 7700) to no test .
3. After the relay test, reset the heat pump (line 6711).
M8009 2147EN 33 (74)