01/04/2021
Page 5
4. SHIFT LEVER
The shift lever is placed
Gears positions
on the left side of the engine. The neutral (N) is placed before the first gear.
4.1.
REVERSE SHIFT LEVER
The shift lever is placed
Gears positions.
On the left side of the engine. The neutral (N) is placed before the first gear.
5. REFUELING
To refuel:
•
Place the motorbike on the rear stand.
•
Turn the tank cap counterclockwise to remove it.
•
Refuel, taking care not to overfill the tank causing spills.
•
Insert and screw in the tank cap making sure it is properly closed.
6. ENGINE RUNNING-IN
During the first 2 hours of use, follow the instructions below to ensure future reliability and performance of the
motorcycle.
•
Leave the engine running at the minimum rotation speed for a few minutes before use the motorcycle.
•
Avoid turning on the gas completely.
•
Avoid rapid acceleration and hard braking.
•
Do not exceed the specified engine performance:
After completing the running-in
, it’s recommended to upshift within the engine RPM ranges indicated below. If you
have the
Alfano 6
dashboard (optional), it is advisable to set the switch on of the last two red LEDs for the minimum
and maximum value of the ranges indicated here:
Hours of use
Throttle opening
From 0 - 30 minutes.
Up to and not over 1/2.
From 30 - 90 minutes.
Up to 3/4.
From 90 - 120 minutes.
Up to 100%
ENGINE
RANGE UPSHIFTING (RPM)
110 4S
10000 / 10200
160 4S
10000 / 10200
190 DAYTONA
10200 / 10400
NOTE
For a correct use, avoid the start of the limiter, but take advantage of the torque of
the engine.
NOTE
To avoid gearbox problems, you MUST pull the clutch lever for up and down shifting.
