OHTAKE NJ Series, Operation Manual

Page: 5 / 8

- ４ -
《
Setting a set count → PRESET
》
-You can set or change a set count when SET TOTAL is “0000”.
Clear the SET TOTAL field. (See the next page.)
-You can set a single digit number by the RESET button (the right
PRESET button) and a tens digit number by the CLEAR button (the left
PRESET button).
-When you press down and hold on one of the PRESET buttons, the
buzzer beeps in about 2 seconds; another 2 seconds later, it beeps again
and the digit above the button will flashes on the LCD panel.
In this status, you can change (or set) a value on the digit, The value on
the digit changes each time you click the button.
-To set the value, just wait the value stops flashing,
You can use either of the PRESET buttons to set a value on the flashing
digit.
《
Changing the sound volume → VOLUME SET
》
-You can change the magnitude of beeping of the buzzer. Press both
VOLUME SET buttons (NO COUNT and PRESET buttons) at the same
time for about 4 seconds. The COMPLETION indicator flashes. Now you
can change the volume.
-The beeping volume changes in the order below by pressing the RESET
button while the COMPLETION indicator is flashing.
Minimum→Medium→Maximum→Mute→Minimum→Medium→….
-To set the beeping magnitude, wait untill the indicator stops flashing.
Turn on Automatic Screw Feeder and set or change counts while the screw feeder is at rest.
《ＰＲＥ ＳＥＴ》
Set a set count.
《ＶＯＬＵＭＥ ＳＥＴ》
Set a beeping
magnitude.
Setting on the panel before starting screw feeding