Timing Chart 2
Irregular extracting stop and restarting operation
Screws taken out before the set number results in an irregular extracting and the machine stops.
For restarting, do as follows.
Reset the PLC to the original, desired operation.
After detecting an irregular extracting, it remains in OUT1 and so must be reset to the original desired operation.
[OUTPUT/INPUT colored areas are Low output.]
LED
POWER
Complete
OverLoad
OUTPUT
OUT1
Request
※1
※1
※3
OUT2
Waiting to extract
※2
OUT3
Waiting to extract
OUT4
Request 1
OUT5
Mid-operation
OUT6
Request 2
OUT7
Overloaded
OUT8
Irregular extracting
INPUT
IN1
Starting
※4
※4
IN2
1st bit
IN3
2nd bit
IN4
3rd bit
IN5
4th bit
IN6
5th bit
IN7
6th bit
IN8
7th bit
External operation
Power ON
Extracting
※5
※6
Internal operation
Setting screw number
Feeding motion
Count completed
Waiting
※1：2 seconds after detecting an input signal on IN1, OUT1 changes.
※4：When OUT1 is Low output, screw number (IN2～8) is set by switching H/L on IN1
※5：Screws taken out in mid-feed results in an Irregular Extracting Stop.
※3：2 seconds after OUT2 changed, OUT1 changes.
※6：Restarting solves the irregular extracting stop.
Flashing
Flashing
※2：OUT2 doesn't change for at least 2 seconds.
Depends on setting
