–
１８
–
Symptom
Cause
Action
8-2
Screws won’t come flowing
• The brush cannot brush away screws in an
abnormal posture.
• The shank of a screw has entered the
passage window.
• Screws have been stopped in an unusual
posture halfway in the rail.
• The rail can't move longitudinally (due to
screws stuck in rail gaps, for example).
• Improperly adjusted timer setting control
screw
• Adjust the brush.
Adjust the passage plate.
Putting an appropriate supply of screws in the
Screw bin could fix the problem.
• Remove unusual screws and then adjust the
passage plate.
• Remove the screws in an unusual posture.
Follow the instruction given below to remove
screws. In doing so, be careful not to scratch the
rail groove and other components.
Loosen the bit guide assembly setscrew.
Move up the Holding plate.
Remove the screws in an unusual posture.
Then, adjust the Holding plate position.
• Remove the screws stuck in gaps.
If no screws are stuck, contact our service to
resolve the problem.
• Adjust the timer setting control screw again.
