Check that the passage window is adjusted at such height that
allows the Applied screw to pass barely.
Applied screw
Passage plate
mounting screw
Passage window
(notch in the
passage plate)
Passage plate
Vertical adjustment
Turn the power switch on, then off to keep the brush roughly level.
Brush
Brush height
adjustment screws
Moving the brush by hand, check that the tip of the brush rubs on
the head of the Applied screw placed in the rail groove.
Brush
Passage
plate
Brush height
adjustment
screws
Brush assembly
mounting screw
Applied screw
–
１０
–
5.4 Brush Check and Adjustment
Turn off the power switch before performing check
and adjustment work.
Put a screw to use in the screw bin and turn the power switch on, then off
to place the screw into the rail groove.
• Turn the power switch on, then off to keep the brush roughly level as
shown at right.
• Check that the tip of the brush swipes above the head of the applied
screws placed in the rail groove.
• The alignment and transfer of screws would be adversely affected if the
brush is positioned too high or too low.
• If the brush requires adjustment, loose the brush height adjustment
screws.
• If the front of the plastic part of the brush hits the passage plate, loosen
the brush assembly mounting screw and adjust its longitudinal position.
• Run this machine to check that the brush works correctly.
5.5 Passage Plate Check and Adjustment
Turn off the power switch before performing check
and adjustment work.
• Check that the passage window is adjusted at such height that allows
the applied screw to pass barely.
• Too low a passage window would not allow screws to pass, and
too high a passage window would make screws more liable to stop
delivery.
• If the passage pate requires adjustment, loose the passage plate
mounting screw.
• When the adjustment is complete, verify correct operations.
CAUTION
CAUTION
