2
1
Put the motorcycle on a work stand so that the
rear wheel barely touches the ground.
2
Remove the fairing screw at the bottom.
3
Remove the lambda cable clip from the frame.
4
Remove the exup cable behind the rear brake
fluid reservoir.
5
Be careful with the lambda and the exup cable.
Loosen and move the silencer to the right.
6
Remove the shock absorber screws and the
link screw fromt he swing arm.
7
Remove the original shock absorber.
Mou tI g I StRuCtIo S
arninge!
⚠
We strongly recommend to let an Öhlins dealer
install this product.
arninge!
⚠
If you work with a lifted vehicle, make sure that it
is safely supported to prevent it from tipping over.
otee!
1
When you work with this product, see the
vehicle service manual for vehicle specific
procedures and important data.
otee!
1
Before you install this product clean the vehicle.
8
Install the Öhlins shock absorber.
9
Remove the lower left rear sub frame screw.
use the screw provided in this kit and install the
hydraulic preload adjuster on the inside. Rotate
the adjuster up as much as possible before you
tighten the nut.
10
Install all removed parts in the same positions
that they were before removal.
otee!
1
Lower the vehicle so that the suspension
is slightly compressed before you tighten
the screws.
Cautione!
✋
Make sure that you tighten all screws to the
correct torque and that nothing fouls or restricts
movement of the shock absorber/front fork/
steering damper when the suspension is fully
compressed or extended.
