OHAUS TD52P, User Manual

Page: 6 / 80

EN-4
2.2.1 Opening the Housing
CAUTION: ELECTRICAL SHOCK HAZARD. REMOVE ALL POWER CONNECTIONS
TO
THE INDICATOR BEFORE SERVICING OR MAKING INTERNAL
CONNECTIONS. THE HOUSING SHOULD ONLY BE OPENED BY AUTHORIZED
AND QUALIFIED PERSONNEL, SUCH AS AN ELECTRICAL TECHNICIAN.
TD52P
Remove the four Phillips head screws from the rear housing.
Remove the front housing being careful not to disturb the internal connections.
Once all connections are made, reattach the front housing.
TD52XW
Remove the four hex head screws from the rear housing.
Open the housing by carefully pulling the front housing forward.
Once all connections are made, reattach the front housing.
The screws should be tightened to 2.5 N•m (20-25 in-lb) torque to ensure a watertight seal.
2.2.2 RS232 Interface Cable to TD52XW
Pass the optional RS232 cable through the strain relief (Figure 1-2, item 10) and attach it to terminal
block J7 (Figure 1-3, item 6). Tighten the strain relief to maintain a watertight seal.
3. Menu Structure
TABLE 3 MENU STRUCTURE
Calibration Setup Read Out
Application
Mode
Zero
Capacity Unit Stability Weighing
Span Range Zero Range Counting
Linearity
Capacity
&
Graduatio
n
>|1|< Capacity Filter Level Check
GEO >|1|<Graduation
Auto Zero Tracking Percent
>|2|< Capacity Auto Dim Dynamic
>|2|<Graduation Brightness Reset
Language Screensaver
Power On Zero Auto Off
Power On Unit Adjust Contrast
Key Beep Reset
Transaction Counter
Next Transaction
Password
Reset
Weighing Unit GLP/GMP Data Communication SDCARD Maintenance
kg Date Format RS232 Library Export Menu
lb Date *2nd RS232 Memory Import Menu
g Time Format *RS485 User Diagnosis
oz Time *Ethernet Service Menu
lb: oz Project ID *Wifi
t Scale ID *Bluetooth
®
ton Reset *Analog
Custom Unit
Reset
* Sub- menu for options will be active only when the specific board is installed.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by
OHAUS is under license.