STARTER 3100M Bench Meter
EN
-
13
3.3
Sample Measurement
3.3.1
pH measurement
Place the pH electrode in the sample. Stir for 5 seconds; wait for 30 seconds.
Press
to start the pH measurement, appears on the display. is blinking during
measurement.
When meter reaches endpoint, the pH value with the temperature display on the screen.
3.3.2
mV measurement
Press
to switch between
pH measurement mode
and
mV measurement mode
.
Follow the same procedure as for pH measurement to perform mV measurement.
4
ST3100M Conductivity Operation
After turning on the meter by pressing
,
press
to switch from pH parameter to
conductivity parameter.
4.1
Setup
4.1.1
Set temperature unit
Press and hold
until the set up icon
appears on the display and the current
temperature unit blinks. (
°C or °F)
Use
or
buttons to select temperature unit .
Press
to confirm your setting. Continue with temperature value setting by
following or press
to go back to the measurement screen.
Note:
°C
= 5/9 (
°F
-32)
4.1.2
Set MTC temperature value
After the temperature unit setting, the meter goes to setup manual temperature (MTC) value
setting.
Use
or
buttons to adjust the temperature value.
