SCOUT
TM
SERIES BALANCES - SPX EN-13
Exponent
Set the factor multiplier.
-3 = divide the Factor by 1000 (1x10
-3
)
-2 = divide the Factor by 100 (1x10
-2
)
-1 = divide the Factor by 10 (1x10
-1
)
0 = multiply the Factor by 1 (1x10
0
)
1 = multiply the Factor by 10 (1x10
1
)
2 = multiply the Factor by 100 (1x10
2
)
3 = multiply the Factor by 1000 (1x10
3
)
Least Significant Digit
Set the graduation.
Settings of 0.5, 1, 2, 5, 10, 100 are available.
Note: Custom Unit is locked at Off position when the Security Switch is set to the locked
position.
Follow below instructions below to enter the unit menu to set the Custom Unit.
Press and hold
Menu
until [
mMeNU
] is displayed. When the button is released, the display will
show [
C.A.L
]. Press
No
through the succeeding menu items:
[
C.A.L
], [
SEtUP
], [
mModE
] until [
Unit
] is
displayed.
1. When [
Unit
] is displayed, press
Yes
.
2. [
rESEt
] will be displayed. Press
No
, [
Unit
g
] will be displayed.
3. Press
No
to toggle through active units until [
Unit
c
] is displayed.
4. Press
Yes
, [
On
c
] will be displayed, then press
Yes
.
5. [
Factor
] is displayed. Press
Yes
to view the default Factor. Press
Yes
to accept or
No
to edit
the “factor multiplier”. The stored value is then displayed with the first digit highlighted
[
1
.0000000
]. Repeatedly press
No
until the desired number appears. Press
Yes
to accept and
highlight the next digit. Repeat until all the digits are correct. Press
Yes
to accept the “Factor”
value.
6. [
EPt
] is displayed. Repeat the same procedure as in step 5 to accept or edit the “Exponent”
value. Press
Yes
to accept the “Exponent” value.
7. [
LSd
] is displayed. Repeat the same procedure as in step 5 to accept or edit the “Least
Significant Digit” value. Press the Yes key to accept the graduation value, [
End
] is displayed.
8. When [
End
] is displayed, press
Exit
to exit to weighing mode.
(866) 433-6682 • (281) 359-8538 • [email protected] • www.novatech-usa.com
