OHAUS HH 320, Operating Manual

Page: 5 / 40

5
Declaration of Conformity We, Ohaus Corporation, declare under our sole responsibility that
the balance models listed below marked with "CE" are in conformity with the directives and
standards mentioned.
Marked with: EC Directive (Including applicable amendments) Standard
89/336/EC EN61326:1997 + A1:1998
Electromagnetic compatibility Electrical Equipment for Measurement,
Control and Laboratory Use
- EMC requirements
Immunity - Performance Criterion B
Emissions - Class B
ISO 9001 Registration for Ohaus Corporation
. .
. . .
Ohaus Corporation, USA, was examined and
evaluated in 1994 by the Bureau Veritas Quality International (BVQI) and was awarded ISO 9001
registration. This certifies that Ohaus Corporation, USA, has a quality system that conforms with the
international standards for quality management and quality assurance (ISO 9000 series). Repeat
audits are carried out by BVQI at intervals to check that the quality system is operated in the proper
manner.
Last two digits of the year which the CE marking was affixed: 02
Ohaus Corporation, 19A Chapin Road, P.O. Box 2033, Pine Brook, NJ, 07058-2033
,
USA
Scale model (s) Hand-Held HH 120 and HH 320
Ted Xia
Ohaus Corporation, Pine Brook, NJ USA n
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
80250884.pmd 3/23/2005, 9:53 AM 5