OHAUS C51XE100L, Instruction Manual

Page: 33 / 40

CATAPULT 5000 SERIES SCALES EN-27
6. MAINTENANCE
CAUTION: DISCONNECT THE UNIT FROM THE POWER SUPPLY BEFORE CLEANING.
6.1 Cleaning
• The housing may be cleaned with a cloth dampened with a mild detergent if necessary.
• Do not use solvents, chemicals, alcohol, ammonia or abrasives to clean the housing or control panel.
6.2 Troubleshooting
TABLE 7-1. TROUBLESHOOTING.
Error Code Description Cause
Error 8.1 Power On Error Weight reading exceeds Power On Zero limit.
Error 8.2 Power On Error Weight reading below Power On Zero limit.
Error 8.3 Over Range Error Weight reading exceeds Overload limit.
Error 8.4 Under Range Error Weight reading below Underload limit.
Error 8.5 Tare out of range Error Tared at one unit but after switching to another unit the tare
value exceed the max.
Error 8.6 Display Overflow Weight exceeds 6 digits. Happened in the cases of
Accumulation or counting PCS display
------- Busy message Displayed during tare setting, zero setting, printing
--NO-- Action not allowed message Function not executed.
Battery icon flashing Low Battery error Battery is empty
CAL E Calibration Error Calibration value outside allowable limits
Lo.rEF Low reference weight warning
message Average Piece Weight too small. (Warning)
rEF.Err Unacceptable reference
weight message Reference Weight too small. The weight on the pan is too small
to define a valid reference weight.
6.3
Service Information
If the troubleshooting section does not resolve your problem, contact an authorized Ohaus Service Agent. For
Service assistance in the United States, call toll-free 1-800-526-0659 between 8:00 AM and 5:00 PM Eastern
Standard Time. An Ohaus Product Service Specialist will be available to assist you. Outside the USA, please
visit our website www.ohaus.com to locate the Ohaus office nearest you.
7. TECHNICAL DATA
7.1 Specifications
The technical data is valid under the following ambient conditions:
Indoor use only
Ambient temperature:
-10°C to 40°C / 14°F to 104°F
Relative humidity: Maximum relative humidity 80% for temperatures up to 31°C decreasing
linearly to 50% relative humidity at 40°C.
Altitude: up to 2000m
Mains supply voltage fluctuations: up to ±10% of the nominal voltage
Installation category:
II
Pollution degree: 2
Protection class: III