42
MENUS
Custom Unit or Volume Selection (Cont.)
14.
ON
TARE
.
15.
MODE
,
,
,
. Selecting NONE disables the
volumetric units.
16.
ON
TARE
.
NOTE: To use this function the printer must be on and all communication parameters
must be set first.
Operating Procedure
1. Place a container on the platform,
ON
TARE
to tare the container .
2. Fill the container.
3.
, printer will now print out quantity of selected unit of measurement.
Good Laboratory Practices
Good Laboratory Practices (GLP) submenu allows the selection of Time, Balance Identifi-
cation Number, Identification Number, Project Number, Calibration and Name data to be
printed. The purpose of this submenu is to permit the printing of the above selected items.
These items are not displayed. The default setting is off.
When an external printer is used, and all items are set ON and the balance is calibrated, the
printer will print out calibration data for audit trail purposes and will indicate date, and time.
The Balance ID number is entered through the RS232 command xxxxID. It should be noted
that the ID number and Project number must be entered in the Print/GLP submenu before
printed data is available. Since all of the settings for the GLP submenu are done in a similiar
manner, only one example is shown.
1. Access the
submenu under
SETUP
Options menu.
2.
ON
TARE
.
3.
ON
TARE
.
4.
MODE
or
.
5.
ON
TARE
.
6. Repeat steps above for Balance ID#, ID#, Project#, Calibration and Name.
NONe
lITeR
^]l
fl 02
·uaRT
DeNsITy
9lp
TI^]e
oN
oN
off
TI^]e
Menu
Menu