OGI TotalArc BMS 460246 SOLAR POWER, Operator'S Manual, Page: 20 / 24

TROUBLESHOOTING
11
ISSUE SIGNAL MEANING REACTION POTENTIAL CAUSES
Pilot
Relighter
Lockout DOUBLE FLASH LOCKOUT - with
burner TCV
DISABLED Two-minute burner
shutdown condition to
allow BASO to cool
down.
•
BASO Pilot Guard Valve or
Thermocouple issues.
Confirm BASO gas supply
and operation.
•
Improper positioning of
ignitor/flame rod to Pilot
Head (See figure 6 Page
IV)
•
Poor ground between
Relighter Ignition Module (in
flame arrestor) and Pilot
Head
Low Battery Voltage (11.50
Volt minimum required)
•
Pilot ignition / sensing cable
connection
•
Poor termination of pilot
ignition / sensing cable
•
Confirm electrical insulating
rubber boot is installed.
SINGLE FLASH LOCKOUT - with
burner TCV
RELEASED: the
system has
maintained the main
gas closed for a
period of two-
minutes and has
now been released. TotalArc main gas
valve released to
OPEN; BASO Pilot
Guard should cool
down and close main
gas valve
No Pilot
Flame Ignited
FAST BLINK –
Right after
START/RELIGHT
BURNER push
button is pressed
Ignition process Spark present at
ignition rod
•
Confirm Spark Gap (See
Figure 6 Ignition Rod
Installation Page IV)
•
BASO Pilot Guard Valve or
Thermocouple issues.
Confirm BASO gas supply
and operation.
•
Improper positioning of
ignitor/flame rod to Pilot
Head (See figure 6 Page
IV)
•
Poor ground between
Relighter Ignition Module (in
flame arrestor) and Pilot
Head
•
Low Battery Voltage (11.50
Volt minimum required)
•
Pilot ignition / sensing cable
connection
•
Poor termination of pilot
ignition / sensing cable
•
Confirm electrical insulating
rubber boot is installed.