Oerlikon Fairfield Torque-Hub S40B Series, Service Manual, Page: 23 / 48

23
9.
Inspect Planet Shaft (2K) for nicks and burrs. Insure that planet shaft hole and planet shaft
are free from debris, burrs, sharp corners. Start the Planet Shaft (3E) on the wide side of the
Carrier (2A). Install Planet Shaft (2K) through large diameter in the carrier hole and through
planet gear bearing inner race by aligning the lock pin slot in both carrier and planet shaft.
10.
Install Lock Pin (2J) into lock pin slot in Carrier (2A) and Planet Shaft (2K).
11.
Install Tanged Lock Washer (2I) onto Planet Shaft (2K).
12.
Clean threads on Planet Shaft and Bearing Nut. Apply Loctite-263 and install Bearing Nut
(2H) onto Planet Shaft (2K) by using tool T-136699 Tighten Bearing Nut (2H) and measure
rolling torque of planet gear using a fish scale. Torque Bearing Nut (2H) until 1.5
– 2 lbs of
drag is achieved while rolling Planet Gear (2B).
13.
Bend tang into Bearing Nut Slot (2H) slot.
14.
Repeat steps from 2 through 14 for the remaining Planet Gears (2B).
This concludes the Input Carrier Subassembly.