3
Operating Instructions and Parts Manual
24815
SANDBLAST BENCH TOP CABINET
5/19
2019 OEMTOOLS
™
A - Foam Vent Filter
B - Air Vent Cover
C- Ceramic Nozzles 4, 5, 6 & 7mm
(One nozzle is fitted)
D - Gun with air and pick up hoses
E - 12V transformer w/cable
F - Abrasive pick up
G- PTFE Tape.
ASSEMBLY
Carefully unpack the unit, and check to ensure that no
damage was caused in transit. Should any damage
be apparent, please contact OEM at 1-866-458-2472
immediately. Remove all components from inside the
cabinet, and check them against the following list.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
The unit is shipped completely assembled, except
for the air vent filter and the gun with attached hoses.
These should be connected as follows: First, remove
the grid, and all the various components, from within
the cabinet. The end of the air inlet hose, connected to
the gun, is inserted through the 16mm dia. hole in the
cabinet, from the inside, as shown in Fig. 2. Ensure a
flat washer is threaded on to the adapter, as shown.
Thread a flat washer, followed by the extended
nut, on to the adapter, from the outside of the
cabinet, and tighten.
Connect the grit pick up hose to the pickup and
tighten the worm drive clip securely. Locate the
pick up on the floor of the cabinet. It is secured
with the two spring clips as shown in Fig 3.
Replace the grid, ensuring the feet face down-
wards with the cut away section at the right hand
rear of the cabinet. The pick up hose should be
routed through the gap made by the cut away por-
tion of the grid.
Insert the circular foam filter into the recess in the
Air Vent Cover, and attach the cover to the rear of
the cabinet as shown in Fig.4, having first pried
out the plastic bung from the vent hole.
Finally, connect the air supply to the extended nut
shown in Fig.5. Use of the PTFE tape supplied will
ensure an airtight seal.
The air supply should be dry, and capable of delivering
a minimum of 10 cu. ft./min at 100 PSI
