OEM KPM216HII, User Manual

Page: 85 / 88

10.4 Printing area
In order to print ticket containing only one notch and to not overlay printing to a notch (that will make it useless for the
next alignment), it is important to well calibrate:
• The height of the printing area of ticket according to the inter-notch distance
• The value for the paper recovery after a cut
The following fi gure shows an example of tickets with “Notch Distance” set to 0:
PRINTING
AREA
Printing line
Cutting line
A D H A
L
direction of
paper feed
A “Non-printable area” of 3mm generated by:
“Distance between cutter/printing head” - “Value for the paper recovery after a cut”
where:
“Distance between cutter/printing head” = 30mm ( fi xed distance)
“Value for the paper recovery after a cut” = 27mm ( fi xed distance)
H Distance between the fi rst and the last print line, called “Height of the printing area”.
L Distance between an edge of the notch and the next one, called “Inter-notch distance”.
D Automatic feed for alignment at the next notch.
To use all the notches on the card, you must comply with the following equation:
H + A ≤ L
The height of the printing area (H) can be increased to make no progress on alignment (D = 0) but no further.
10. ALIGNMENT
User manual
KPM216HII 85