5
3. Attach LCD-TV mounting arm
a. Use a 5mm hex wrench to remove the two (2) lower hex
screws securing the footrest to the mast.
b. Hold the LCD-TV mounting arm (A) near the console mast
and route the power cord and coax cable under the bracket
and up through the channel in the mounting arm.
Make
sure that the console cables are out of the way so
that they don’t get pinched.
c. Place the upper clamp bracket over the top of the console
plate. Do not tighten the screw at this time.
d. Holding the cables at the top, push the mounting arm firmly
against the console plate. Align the slots in the LCD-TV
mounting arm tabs with the threaded holes in the back
of the console mounting plate. Insert the 18mm Phillips
screws originally used to hold the console back cover in
place. Ensure all cables are out of the way, then finger-
tighten to hold the arm in place.
e. Place the LCD-TV mounting arm over the footrest bracket
and re-insert the hex screws into the mast.
f.
Tighten all four (4) screws to secure
.
Tighten upper clamp
bracket screw
.
Do not overtighten
.
4. Attach screen to mounting arm
a. Connect the power cord, controller cord, and coaxial cable to
their appropriate connectors on the back of the LCD-TV.
b. Hang the LCD-TV mounting bracket (B) on the top bracket of
the LCD-TV mounting arm (A).
c. Insert one (1) screw with captive washer (H) into each end of
the bottom shaft on the screen mounting bracket (B); use the
T-handle hex wrench (M) to tighten.
d. Use the T-handle hex wrench (M) to tighten the screws in the
top shaft of the screen mounting bracket (B).
e. Use the cable ties (L) as needed to secure any loose cables.
Tighten to secure
mounting arm to
console plate