4
1. Attach screen mounting bracket to LCD-TV
WARNING!
Do not mount an LCD-TV weighing more
than
8.5 lbs. (3.8 kg)
on the LCD-TV mounting arm.
a. Position the screen mounting bracket (B) on the back of the
LCD-TV, aligning the screw holes on the bracket with the
screw holes on the back of the LCD.
b. Attach the screen mounting bracket (B) to the LCD-TV using
four (4) Phillips screws (I or O); tighten.
Note: If your screen has a recessed pocket, use the
included spacers (J) and 20mm Phillips screws (K) for
mounting the bracket (B).
c. Insert one (1) hex screw with captive washer (H) into each
end of the top shaft on the screen mounting bracket (B) and
partially thread the screw into the shaft. Set the LCD-TV with
attached mounting bracket aside.
2. Route cables and power cord
With assistance, tilt the unit to one side to install and secure power
cord according to the following instructions:
a. Connect the coaxial cable with coupler (F) to the coax
connection at the top of the frame. Tighten to secure.
b. Feed the loose end of the coax cable up through the hole in
the bottom of the mast and out through the hole beneath the
console mounting plate (with the other cables).
c. Route the power cord that will plug into the back of the LCD-
TV through the hole at the base of the elliptical, under the
lower front shroud on the user’s right side. (You may need to
tip the elliptical up to route the cord.) Route the power cord
through the three twist clips that are spaced along the mast
tube on the user’s right side. Twist the clips to secure the
cord in place.
d. Feed the end of the power cord up through the hole in the
bottom of the mast and out through the hole beneath the
console mounting plate (with the other cables).
e. Remove power cord slack from within the unit and secure
excess cable outside the base with attached cable tie.
Note: Complete these instructions during initial assembly of the xRide Commercial Series elliptical
(i.e., xR6000), while mounting the console display on the mast. If you are installing the LCD-
TV Mounting Arm on a fully-assembled elliptical, you will need to remove the console from
the mast and remove the console back cover and the top cover in order to complete these
instructions. It may be easier to route cables if you also remove the right front shroud.
I or O (4)
H (2)
IF YOU HAVE PURCHASED THIS MOUNTING ARM WITH THE OCTANE FITNESS xR6000 ELECTRONIC
CONSOLE WITH PERSONAL TV CONTROL, DISREGARD THESE INSTRUCTIONS AND USE THE
INSTRUCTIONS INCLUDED WITH YOUR CONSOLE.
Secure excess
power cord
outside of base
