7
SOFTWARE MANAGEMENT
The console software includes management functions to help you make the most of your experience with the Octane Rō, including simple
diagnostics to help with troubleshooting and Club (user) settings that may be customized to suit your environment. To access these functions,
press and hold both the Time ( +) and Time ( – ) keys for three seconds, or until you hear a bell. Use the ( + ) key to scroll through the
diagnostics and club setting described below. Press Enter to show the details of a function, to make a change to a user setting, or to run a
diagnostic test. To exit diagnostics, press once or twice Pause Clear until the console resets.
Should you encounter errors or have questions regarding diagnostics, please contact Octane Fitness Customer Service for assistance.
Available options may vary depending upon your software version.
Code
(at the top of the screen
and the center of the tach)
Type
Description
diaG nost 1
Diagnostic
Firmware
. The firmware version, model and console serial number information. Firmware version
number is displayed in the middle of the screen. Model number is displayed in the lower right. The
console serial number is displayed across the lower part of the screen (across several fields). Boot
code version is displayed in the lower left. Press Pause Clear twice to step back to scrolling mode.
diaG nost 2
Diagnostic
LCD Display Test
. Initiates a sequential illumination of all individual segments of the LCD. Press Pause
Clear twice to step back to scrolling mode.
diaG nost 3
Diagnostic
Keypad Test
. Press Enter, then press each of the 10 keypad buttons. The name or number of the
pressed button shows on the display and the key counter increments by 1. When all 10 keys have been
successfully tested, “PASS” appears in the display. Press Pause Clear twice to step back to scrolling
mode.
diaG nost 4
Diagnostic
Radio Board Communications
. The console sends test data to the lower board; “PASS” appears
in the display if return data is received. Radio firmware version and heart rate are displayed in the
lower right and lower left part of the screen. Press Pause Clear twice to step back to scrolling mode.
diaG nost 5
Diagnostic
Resistance Level
. Move the resistance level all the way forward and back. Level number is displayed
in the Level field, strokes in the middle, and ADC value and RPM in the lower half of the screen. If ADC
is too high or too low, an error displays in the lower half of the screen.
diaG nost 7
Diagnostic
Battery
. Installed battery and generator volts values are displayed in the lower part of the screen.
Battery state shows near the bottom of the screen; if it is blank or reads “chrg” (charging”, the
battery is good.
CLUB BELL
Club Setting
Bell Volume
. Sets the decibel level of the bell that provides signals during workouts. The options
are Off, 1 (softest), 2 or 3 (loudest), and the default value is 3. Press Enter, then Time ( +) or Time
( – ) keys to scroll through the options. Press Pause Clear once to save your selection and step back
to scrolling mode.
CLUB Brit
Club Setting
Brightness
. Sets the brightness of the display. The default value is 100. Press Enter, then use the
Time ( +) or Time ( – ) keys to increase or decrease the brightness, in 5% increments. Press Pause
Clear once to save your selection and step back to scrolling mode.
Summary of Contents for Octane RO
Page 1: ...CONSOLE GUIDE SET UP INSTRUCTIONS ...
Page 2: ......