6
2. Attach moving handlebars
—
Moving handlebars are
labeled left and right, be sure to install accordingly.
a. Align the bottom of the handlebar (F or G) with the four holes
in the pivot shaft and attach with four 6mm hex key bolts
(K)—
make sure these bolts are very tight; torque to 30
ft-lbs.
b. Reaching inside from the front of the machine, carefully
connect the heart rate cable coming from the base of the
handlebar (F or G) to the cable by the pivot shaft of the
cross trainer base (A).
Gently tug the cable to ensure the
connector is completely seated.
c. Position the handlebar cover (H) over the handlebar pivot
point and press firmly at top and bottom to attach.
d. Repeat for the other side.
Pivot shaft
Cable from
handlebar
Cable on
frame
3. install access panel
a. Loosen the screws on the left and right sides of the lower
shroud near the front of the unit. (These screws secure the
side of the shroud and the access panel to the frame.)
b. Slide the metal plate of the access panel (D) behind the
back shroud. Fit the tabs on each side of the access panel
into the slots between the side of the main shroud and the
frame, over the top of the screws.
c. Tighten the screws on each side, then secure the back of
the access panel with 2 Phillips screws (L).
Tab
Back
Screws
Screw to
loosen on
both sides
Slot for
Tab
1. Attach pedal lever
a. Remove bolt from 3-pivot link.
b. Place right pedal lever (E) through leg slot in rear shroud of
the cross trainer base (A) and attach it to the 3-pivot link.
Check to see that the rollers are seated and properly
aligned on the rails before securing the pedal lever.
c. Tighten the bolt and nut securely using 17mm socket and
wrench.
