16
5.
Multi-Brand IR Remote Controller Setting
NOTE : When there is no input during about 10 seconds from set mode, set mode is
canceled.
1.
Direct Code Entry
Step 1
: Turn on the DEVICE what you want to set up(TV / DVD / VCR)
Step 2
: Press DEVICE and OK button during about 2 seconds at the same time.
DEVICE LED will blink twice.
Step 3
: Input the 3 digit code numbers.
(Refer to
‘Code Table for Universal Remote Control Unit’
in the rear section of this manual
)
DEVICE LED will blink twice and the DEVICE turns off.
If you enter a wrong DEVICE code, DEVICE will blink once
Step 4
: If your DEVICE turns off, press OK button.
DEVICE LED will blink twice.
2.
Auto Code Search
Step 1
: Turn on the DEVICE what you want to set up(TV, DVD)
Step 2
: Press DEVICE and OK buttons during about 2 seconds at the same time.
DEVICE LED will blink twice.
Step 3
: Press UP or Down button within 10 seconds to enter the Search mode.
Step 4
: Press UP or Down button until the DEVICE turns off, one and one.
Step 5
: If your DEVICE turns off, press OK button.
DEVICE LED will blink twice.
3.
Code No. Checking (Number Call)
Step 1
: Press DEVICE and OK buttons during about 2 seconds at the same time.
DEVICE LED will blink twice.
Step 2
: Press INFO button within 3 seconds.
LED will blink according to inputted mode number on the device.
( Case of digit '0', it blinks 10 times.)
