OCI PRO-Performance Series -26BQP, Use And Care Manual

Page: 20 / 36

20
The self-contained LP system appliance is design certified to be used with a standard 20 lb., 12 1/4"
diameter; 18" high cylinder with right handed connection threads and this is the maximum size LP tank
to be used. The cylinder must be marked in accordance with the latest U.S. Department of
Transportation specifications for LP gas cylinders. (DOT. CFR49 or National Standards of Canada
CAN/CSA-B359 Cylinders, Spheres and Tubes for the Transportation of Dangerous Goods) a Propane
Tank with an ODP) Overfill Prevention Device) must be used at all times.
IMPORTANT: Never connect the appliance to an unregulated gas supply.
The installation of this appliance must conform with local codes or in the absence of local codes, to the
national fuel gas code, ANSI Z223.1a-1998. Installation in Canada must be in accordance with the
standard CAN/CGA- B149.2, Propane Installation Code.
A licensed contractor or local gas company representative must perform all natural gas
connections.
Ensure that the service supplying the appliance is fitted with a shut off valve conveniently positioned
near the appliance and giving ease of access.
The appliance must be isolated from the gas supply piping system by closing its individual manual
shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or
less than 0.5 psi (3.5 kPa).
The appliance and its individual shutoff valve must be disconnected from the gas supply piping
system during any pressure testing of that system at test pressure in excess of 0.5 psi (3.5 kPa).
Checking for Gas Leaks
Perform a leak test at least once a year whether the gas supply cylinder has been disconnected or
not. In addition, whenever the gas cylinder is connected to the regulator or whenever any part of the
gas system is disconnected or replaced, perform a leak test.
As a safety precaution, remember to always leak test your appliance outdoors in a well-ventilated
area. Never smoke or permit sources of ignition in the area while doing a leak test. Do not use a
flame, such as a lighted match to test for leaks. Use a solution of soapy water.