OPERATION | Safety
BIA-EUROPA Mini IWP-EN12 | www.ochsner.com 5
1.2 Other symbols
►
This triangular symbol is used as a bullet point.
»
These two arrows represent the symbol for an in-
struction. This shows that there is something you
must do. The actions required are described step by
step.
These symbols show you the level of a software
menu. In this example, 3 menu levels are
indicated.
Symbol
Notes
Must not be disposed of with household waste
Additional documents are available and must be
used
1.3 Units of measurement
Note
In these documents, unless otherwise specified,
all linear measurements (e.g. in tables and illus-
trations) are given in millimetres.
1.4
Specified performance figures
The performance figures of the appliance indicated in
these documents (text, tables and diagrams) have been
calculated according to standardised measurement con-
ditions. However, these measurement conditions often do
not completely correspond to the plant-specific conditions
applicable in the respective user‘s system.
System-specific
factors that can affect the conditions include, for example,
the specific design of the system, the age of the system
and the actual flow rates.
For this reason, the stated perfor-
mance figures can differ from plant-specific performance
data.
The stated performance figures can be confirmed only
if the measurements taken for the appliance are carried
out according to the relevant standardised measurement
conditions.
2. Safety
2.1 Intended use
The appliance is intended for heating DHW in a domestic
environment. It can safely be used by persons who have re-
ceived no instruction. The appliance can similarly be used
in a non-domestic environment such as commercial prem-
ises, as long as it is used in the same intended manner.
Any use of the appliance that is different from or goes
beyond this is not regarded as intended use. “Intended
use” also includes observing this documentation and the
documentation of any accessories used.
2.2 General safety information
Observe the following safety information and instructions
for the appliance.
►
Only qualified contractors should carry out the elec
-
trical work and installation of this appliance. Only
qualified contractors may open the appliance.
►
Commissioning and maintenance of the appliance
may be carried out only by OCHSNER Customer Ser-
vice or by customer service partners authorised by
OCHSNER.
►
The qualified contractor is responsible for compliance
with all relevant regulations during installation and
commissioning.
►
Operate the appliance only when fully installed and
with all safety devices fitted.
►
Alterations to the appliance may be carried out only
by OCHSNER Customer Service or by customer ser-
vice partners authorised by OCHSNER.
►
Before commencing electrical connection and instal-
lation work, the heat pump system must be isolated
from the power supply.
►
The appliance must not be used as a step or plat-
form. Do not climb on the appliance or place any
loads on it.
►
The water in the DHW tank can be heated to temper-
atures above 60°C. If the outlet temperature exceeds
43°C, there is a risk of scalding.
WARNING: Burns
Work on the refrigerant circuit may be carried out
only by OCHSNER Customer Service or by cus-
tomer service partners authorised by OCHSNER.
