installation and determine where will be more convenient to place the
ATM105A gateway.
- Make sure the power is off before you start installing this product.
- It is recommended that all instruments are interconnected through
this gateway. That way the wiring is reduced and increases the
communications performance.
- The ATM105A2 and A3 versions have relay outputs to control anchor
windlass. These outputs
(1 Amp maximum)
are connected in the
same points of the relay box that footswitches on deck. Therefore, the
passage provision must be provided over a 3-wire cable from the base
to ATM105A to said relay box.
Installation:
The equipment must be positioned bolted to a vertical base, with
connections at the bottom, in a place free of condensation, at a height
of 1m above the float level and outside enclosures or metal wires.
- Power Connection, Seatalk and anchor windlass:
NOTES:
- If "Power +" is not connected to Seatalk bus, the supply voltage will
be from 8 to 28V. You do not need fuse, since the equipment
incorporates an automatic inside.
- (Suited) Install a 1.5 A fuse in the Archor COM wire.
- For more detailed information, see the manual "TECH INFO
ATM105A.pdf".