SPORTS SERIES
Single / Dual / Colours / DMX
.
INSTALL & OPERATION MANUAL
1
Preface
READ AND FOLLOW ALL INSTRUCTIONS IN THIS MANUAL
CAUTION
(Risk Group 2): Possibly hazardous optical radiation emitted from this product. Do not stare at operating
lamp. May be harmful to the eye.
CLASS 3
This equipment is designed to operate at voltages of less than 50v DC.
WARNINGS
Before installing your OceanLED Light, read and follow all warning notices and instructions that are included.
Failure to follow safety warnings and instructions can result in property damage, severe injury, or even death.
Before installing your OceanLED Light, check local laws for restrictions regarding the use of colored lights
in your area.
Ensure the mounting location is flat and check internally for ease of access if there is a rib, strut, or other
hull that may interfere with the installation. Avoid mounting lights on surfaces that are subjected to high-
speed water impact, such as planing surfaces.
It is advised not to operate lights out of water for a period longer than 5 minutes. Please make sure lights are
fully cooled down before re-testing out of the water. Exceeding this may cause damage to the light unit.
Salt is an inherently corrosive material. Metal parts and certain natural and man-made surfaces are
particularly susceptible to corrosion and deterioration when used in and around saltwater. Some OceanLED
lights contain combinations of plastic and polymer products that are impervious to saltwater corrosion;
however, screws and fasteners used for the installation must be of a marine-grade type stainless steel or
equivalent and should be monitored annually to ensure the lights remain in service for years to come.
Never use solvents such as cleaners or fuel, as these products may contain strong solvents like acetone.
Solvents can attack many plastics, greatly reducing their strength and causing irreversible damage to
special lens coatings and cable sheathings. Never connect or disconnect lights with power applied, as
irreversible damage may occur. Ensure the polarity of power connections is correct. Failure to do this may
invalidate the warranty.
Never clean lights using a high-pressure jet wash; this will invalidate the warranty. Please avoid coating the
front of the light/lens without consulting OceanLED. Failure to do so will invalidate your warranty.
If bottom painting your lights, ensure the lens and the white plastic retaining ring are free of any paint or
residue.
Do not submerge your cable ends in water; cables and connections exposed to underwater submersion will
not be covered by the warranty. Mounting the light in any other configuration other than those described in
this guide will invalidate its warranty.
