6.1
POWER UP SEQUENCE - DMX CONTROLLER:
Before powering up the system, ensure the necessary connections are made and
suitable fuses are installed.
1. Upon power-up, all three diagnostic LEDs (Red, Amber and Green) will light up for
1 to 2 seconds.
2. After this, they will flash 3 times and switch OFF.
3. Immediately after they switch OFF, the Green LED will stay ON for approx. 5-8
seconds, after which it will start flashing. This indicates that the unit has booted up
completely and is transmitting DMX data.
6.2
WIFI OPERATION (VIA OCEANDMX CONTROLLER ACCESS
POINT)
The WiFi on the OceanDMX WiFi App Controller can be configured to work in two
ways. As default the controller is configured to be used in ‘direct connect’ mode,
where once powered the unit provides a WiFi Access Point (AP) to which phones /
tablets may be connected:
This would suit installations that did not have an existing on-board WiFi network,
or where the system was required to work independently. OceanLED recommends
that the controller be initially setup and tested using this default method.
WIFI COMMUNICATION
OCEANDMX
CONTROLLER
Operation
6
2 0 1 9 I N S TA L L & O P E R AT I O N M A N U A L
CONTROLLER
KITS
24
