11
2.
Insert the light into the hull, feeding the wire through first and seat into place. Press the light
hard into the hull and twist slightly to spread the sealant around behind the light to ensure good
adhesion.
Fig.2
TIP
: Breakages due to lights falling out of the hull are NOT covered under warranty and can cause serious
bodily injury as can any falling object.
Fig.3
3.
ONLY use the mounting screws provided. Cover the threads with the sealant and screw into the pre-
drilled pilot holes.
WARNING: Tighten the screws with a hand tool ONLY!!
4.
Once you are satisfied that the unit is fully embedded into the hull, you will notice that sealant has
squeezed out from around the perimeter of the light. Using a thinner or cleaner, apply to work rag
and wipe off excess sealant to leave a clean seal. If you do not see sealant squeeze out from the
body, you have not used enough sealant or tightened the unit enough to the hull. Carefully examine
the installation to make sure the seal you have installed on the unit is fully water-tight. If in doubt,
remove light, re-apply sealant and re-install.
5.
Once the light has been installed, you need to use the sheath supplied with the light on the inside
of the hull. The sheath is installed by sliding down the cable and back into the hole cut for the wire
from the inside of the hull. This part is used since the hole for the Amphibian is difficult to clean and
will protect the wire from being pierced by shards of fiberglass which could have become dislodged
during the drilling process.
OceanLED INSTALL / AMPHIBIANS / 053014 / v4.2