17
It is important that the top rail of the guard is set at least 25 mm below the rim of the heater
such that it does not receive heat radiation directly from the heater rocks.
Locating accessories
Thermometer
Inside cabin approx 200mm from ceiling on opposite wall from stove.
Sand timer
Inside cabin – on any wall but away from stove.
Wall light – inside cabin.
Lamp & Shade – Centre wall above bench. Approx 100mm from ceiling.
Low Voltage Lights (deluxe model)
Holes can be drilled where applicable (not factory pre-drilled)
Instruction card – outside cabin.
Sauna Clock (deluxe model) – outside cabin
Sauna Heater – inside cabin
See layout drawing of cabin
Please note sauna heaters do not operate from a 3 pin plug, they require hard wiring using high temperature silicon rubber cable to
BSEN 6141. (not included)
Electricians can normally obtain this from their supplier but in case of difficulty please contact our technical department for further advice.
The length you will require depends upon the distance between where you locate your control box and the heater.
Control Box for Heater
– outside cabin
Please note sauna heaters do not operate from a 3 pin plug, they require hard wiring using high temperature silicon rubber cable to
BSEN 6141. (not included)
Electricians can normally obtain this from their supplier but in case of difficulty please contact our technical department for further advice.
The length you will require depends upon the distance between where you locate your control box and the heater.
If you encounter any difficulty with this assembly procedure or think we could have explained
anything more clearly we would welcome your comments; please
01902 871127 technical help
line.
