16
Before attaching the Regulator to the tank:
Slowly open then close the tank's valve for a second to allow a momentary flow of
breathing gas to blow any moisture or contaminants from the gas opening in the tank
valve.
Examine the threads in the valve to ensure they are clean and free of burrs or defects
that could damage the threads of your regulator DIN fitting.
To attach the Regulator to the tank:
Remove the dust protector from the yoke by turning the easy-grip knob in a counter
clockwise direction.
Place the yoke connector over the tank valve, positioned with the seating surface
against the valve o-ring.
Turn the easy-grip yoke knob clockwise until secure.
Slowly open the tank valve (with the pressure gauge facing away from you) and listen
to ensure that no breathing gas is leaking from the regulator/tank connection.
If any leakage is observed, repeat the attachment procedure and inspect the sealing
o-ring. If breathing gas still leaks, DO NOT USE! Take the regulator and tank to an
Authorized Oceanic Dealer for inspection and service.
To remove the DIN to USA Converter:
While holding the DIN connector wheel firmly, turn the DIN to USA Converter counter
clockwise off the threads of the first stage DIN connector. DO NOT use tools to re-
move.
Place the protector cap on the threads of the regulator DIN connector wheel.
All manuals and user guides at all-guides.com
