Sauna & Steam
Oceanic Saunas 01902 450 550 sales
@oceanic-saunas.co.uk www.oceanic-saunas.co.uk
14
Sauna Heater Manual
8.6. Component connections.
Sauna heater, Control box ,controller ,light ,fan and temperature sensor connection drawing (Fig
12) Door interlock install the switch following the manufacturers instructions and connect the
wires back to the control box as shown below.
8.7. Heater Guard (not supplied)
The heater should be guarded against accidental contact with a wooden guard similar to the one
shown below – according to the position of the heater within the cabin it may need to be guarded
on 2 or 3 sides.
Fix the guard in place around the heater by drilling screwing accordingly.
Note:It is important that the top rail of the guard is set at least 30 mm below the rim of the heater such
that it does not receive heat radiation directly from the heater rocks.
8.8. 8.
Sauna stones
Do not use the heater without stones, otherwise it may cause a fire. Only use the original Sauna stone or
the stone for use in heater. Do not use ordinary stones, which may emit harmful substances, easily break
and do not possess good heating capacity. Wash the stones to clear the dust before putting them into
the heater. Stones of unspecified sizes should not be used.
Put the larger stones at the bottom of stove compartment and the smaller ones on top. Do not pile
them tightly so that air can flow freely. NOTE: Too tightly placed stones decrease working time of the
Fig 13
Fig 14
