Ocean Technology Systems MilCom Surface Station 6000S, User Manual

Page: 25 / 32

O
TS MIL
CO
M
SURF
ACE
19
4. Pull the handle apart as you would to rotate it. The handle will now pull free
from the unit.
5.Replace handle with new part by reversing these instructions.
Troubleshooting Guide
Issue Step 1 Step 2
No power, when the Trans-
ducer is connected
-Connect 12 VDC external battery or
12 VDC power supply
-Charge battery
-Change Battery
-Change Transducer cable
Contact OTS.
Squealing noise, when the
Transducer is connected
Disconnect Transducer, wait for 10
seconds. Reconnect Transducer
Contact OTS.
No Transmit -Change Handheld Microphone or
Headset
-Change Transducer
Contact OTS.
No Transmit and Speaker
or Headset does not Mute
-Change Handheld Microphone or
Headset
Contact OTS.
No sound through Speaker -Connect Headset: If there is normal
sound through headset, either bad
speaker or bad PC board.
Contact OTS.
No sound through Headset -Disconnect and use speaker. If sound
is audible from the speaker, bad head-
set or bad PC board
Contact OTS.
Cannot change Channel Contact OTS.
Cannot Turn Squelch On
/ Off
Contact OTS.
Cannot Turn Scrambler
On / Off
Contact OTS.
Scrambler LED turn off,
but unit stuck on Scrambler
mode
-Disconnect Transducer, wait for 10 seconds then recon-
nect Transducer to the unit.
-Contact OTS.
Scrambler LED turns on,
but unit stuck on normal
mode
- Disconnect Transducer, wait for 10 seconds then recon-
nect Transducer to the unit.
-Contact OTS.
Charger LED illuminates
green, Disconnect Charger.
but the unit power will not
activate.
Battery is “dead”. Replace the battery.
Contact OTS.
Charger LED doesn’t turn
green after 12 hours of
charge.
Unplug charger from AC power. Con-
nect transducer to power on the unit.
Check unit for full Indicated charge.
Contact OTS.