15
O
TS MIL
CO
M
REPLACEMENT/SPARE PARTS
Most parts of the MilCom unit can be replaced by the end user. The
Modularity of the system allows for easy replacement of the Battery, Belt
Clip, Transducers and Earphone/Microphone Cables. Any electronic
components of the housing and the Lid Assembly can only be replaced
by Ocean Technology Systems or an authorized technician.
DO NOT use silicone grease on the silicone o-rings. This could cause
swelling and damage of the o-ring resulting in a failure of the pressure
housing. Use only non-silicone grease. Krytox 204 or Tribolube 71 are
acceptable lubricants. Use of silicone based lubricants will void any
warranties.
If you need spare parts contact us at: SALES
@OTSCOMM.COM or
(714) 754-7848
BATTERY REPLACEMENT
1. Using a large flat head
screw driver, loosen the
screws on the bottom of
the unit as shown. Rotate
the screws counter-
clockwise until the screw
comes free from the main
housing.
2. Push on the finger tabs
located on the Rubber
Armored Base to separate
the battery cover from
the rest of the unit. If the
screws were not loosened sufficiently, they may become
stuck. Do not force the unit open. Loosen the screws until
free from the threads. The cover should come free with
gentle force.
3.
After removing the cover, the battery is secured to the cover
by a velcro strip. Simply pull the battery free from the cover
and replace with the fresh battery.
O-RING REPLACEMENT
It is recommended that the o-rings are serviced per
Manufacturer Recommended Maintenance Schedule. Anytime
the Rubber Armored Base or Transducer is removed, the o-rings
