12
O
TS MIL
CO
M
5.
The diver is dressed out such that the wires will not snag,
and the transducer is not obstructed by any type of diving
equipment.
6. In-water surface check:
a. Recheck the location of the earphones.
b. Submerge the transducer to activate unit.
Establish communication with divers and/or surface
station.
c. Look your dive partner over to ensure his
equipment is properly adjusted and the wires are
dressed so as not to snag.
7. Ensure the unit is secured properly to where it is mounted.
POST DIVE PROCEDURE
1. Rinse the unit in freshwater for several mintues or until the
unit is clean. A mild soap solution may be used to remove
contaminants and after cleansing, rinse with freshwater.
2. Dry the transceiver with a clean towel, especially around the
area of the activating water-contact screws. This will ensure
the unit will shut off. Failure to do so will drain the battery
Note: The unit may take a few minutes to turn off; this is
normal.
3.
Store in a dry, safe area.
4. Similar maintenance should be performed on all ancillary
equipment
5.
Routinely clean the water switch contacts with soft brush to
remove any contaminants or oxidation in this area.
